Re: StrangeBrew Vega WIP
Posted: Wed Apr 22, 2015 6:03 am
A lot of us make our own brass motor mounts. It would be very easy to build an AW or SW mount the same way.
Using an old motor can as a drill guide, you can use brass plate or strip, and make a very accurate mount.You could actually make the driveside rear axle holder and motor mount out of one piece if your layout was correct.
Bob
Using an old motor can as a drill guide, you can use brass plate or strip, and make a very accurate mount.You could actually make the driveside rear axle holder and motor mount out of one piece if your layout was correct.
Bob