Routed some of the first pieces yesterday and today.....All are 3' X 7' sections
The squeezes have 2 1/2'' spacing....
I will also make the reverse of this one....
This section is designed to inter on the right, the outer lane veers within 3'' of the outer wall before entering the turn, allowing me to give the inside lane a 12'' dia. turn...
And here is a full size sketch of another section...I forgot to sketch where the barrier divides the 2 sets of turns...
To keep with the 3X7 size the inside turns end up with flat spots at the top of the turns,which I don't care to much for, what do you guys think?