by KD11 » Fri Feb 12, 2016 8:19 pm
An easy way to prevent the ghost cars from changing lanes and crashing into each other or the drivers cars is to put a small piece of black tape over the lane change IR LED on the bottom of the cars, again only on the ghost cars. This will eliminate lots of crashes. I usually run one ghost car on each lane, I have tried to use up to four ghost cars, but the problem is making them run identical speeds and when the speeds differ the slower car always get hit in the rear by the faster car, so what happens is a ghost car pile up or the faster car just pushes the slower car a little faster. Also you can use the Enter/Start button on the controller to stop all cars and the race. Then you have time to get everything ready to go again. Push the Enter/Start button the normal start sequence starts and the race restarts. The good part about this is that all of the lap information, car position on the tower and fuel gauge are not affected and continue as the race was never stopped. Give this a try, if it doesn't work for you then you can move on to the more complex solutions