by chappyman66 » Sun Mar 11, 2018 6:36 pm
With 13V input, I have only turned it down as low as 5.5V.
I can try turning it down farther, but at 6V he can almost keep an NC-1 at full throttle so I haven't gone any lower. The readout is 3 digits so at 10V and above it reads one decimal; below 10V it shows two decimals.
I normally run at 10V, and it doesn't vary more than 0.2V when running. We have that much variation on separate power supplies at a different track. So it doesn't drop off much and I can turn it way down for the kids, which was my goal.
Hopefully this answers the question?