Home Racing World

Good job guys, they look great, good racin!
:banana-dance:

Thanks guys. Tried to do this with a 3D guide. Real issue would be the rubber tire choice and not locking down the front axle. Fun fun fun!
Aloha
Dale

Thanks for hosting and also writing up an exciting recap! I didn't have any luck printing a guide, so in a desperate last minute measure I hillbillied together that Scalextric guide. I hope it holds up and doesn't cause the car too many offs.
Thanks again, I look forward to the next round!
Jamie

Jamie....the shallow guide was tough, yup. Did you try the flags on Thingiverse? There are a couple (including mine) that should print pretty easily. Mine is actually a little too deep, even for Carrera track.

Dale....I was going to try sending your tires....thoughts?

Thanks for building and sending the cars. On to round 2!

Try and see
Thank you for the attention
Aloha
Dale