by Guildman » Thu Jan 19, 2017 11:50 am
The 14mm wheel would be a bit oversized for a 13" wheel and the 15mm wheel is way oversized for a 15" wheel, but a 16" wheel as used on a Maser 300S, for instance would be OK.
However, as the spokes are a) 60 in number, not 70 or 72 and
b) 3D printed and messy looking they aren't suitable for my needs.
BUT, that OSCA does look quite good on them, I must admit.
Most photo-etched wires have a spoke width too great and therefore look too flat and square, but a thickish coat of paint will always round them off a bit and improve the appearance.
Thanks for the help.
Cheers,
Martin