2019 Trans-Am Proxy Round #6 Koolau Motorsports

[lancelotalove]

[arroldn]

Lance,
Thanks for the update. Hopefully my car can move up in the standings. Its been going backwards.

[lancelotalove]

[lancelotalove]

[docdoom]

Looks like my driver has way to many Mai Tais before race start. fell way down the finishing order from were it qualified and were it has been running.... was there a issue? off to the next round and hope for a better showing

[arroldn]

Thanks Lance,
I think if I use the HRS chassis in future builds I'll try for a 3 or 4 point mount vs 2.

Congratulations to our podium finishers. Audi1, Doubleb, Smokeio.

[Pepsi62]

thanks for running the round Lance, many congrats to the podium, well done these top cars are a standout, happy just outside the the top 10 again, look forward to next round

[lancelotalove]

We did have issues with some cars.
#15 has gear issue. Not only is it very noisy, this is holding back the top speed of the car. the crown gear are about gone.
#20 car is slow. During the race it stopped and had something sticking out of the front wheel well. Looks like duct tape? After removal, car went quicker. we think it was rubbing the front wheel or axel.
#19 windshield popped out during 1st heat. glued in after the race.
#74 car is heavy. the front wheel came off on 2nd heat. Found spacer and repaired and continued race.

[Dodgefarmer]

Thanks guys for running this round. Congrats to the podium. Could you please look at the front axle of the #77 Challenger and let me know what is binding on it, as there has been no mention of a bind problem in previous rounds.

Thank You
Randy

[Brumos RSR]

Thank you Lancealotalove and your team for running this round. Congratulations Audi1, DoubleB, and Smokieo on your wins and podiums. The real race appeared to be 5th-11th place that was really close.

[BARC 1]

Thanks for the Run. Not sure what is wrong with the BARC 20. Avant Chassis , and it has not been doing well at all.

[Audi1]

Thanks for running this Round for us, Dale and Lance and company!! It's always great to be able to add a new track and having one now in the 50th state at Koolau Motorsports is a special plus!! Nice pics and graphics on the results, too - thanks for that!

Congrats to Bob (Doubl-B) and Mike (Smokeio) on their podium finishes! This is a tight series, so say the least...…….!!

Thanks also for making the repairs to the cars that needed attention.

The next Round is schedule to be with Rob (cgyracer) at MiD-BC in Kelowna. I'll put you and he in PM contact today so that he can send you his shipping address.

Thanks, again, Dale - a big Mahalo to everyone at Koolau Motorsports!

Allan

[midagekid1]

Hi:

Is the crown gear an easy fix or is the car not drivable....let me know and I can get the car back and send if off to the next race...if it can be repaired, please let me know as well as the cost.

Tom
midagekid1

[Aloha]

Tom it is an 18mm gear and should be 19mm. Gear is worn to the point where it is not driveable.
Easy fix. We can replace slot.it gear and enclose old gear.
Dale

[Audi1]

Hi Tom, The repair to the crown gear can be performed. Either Dale can do it before shipping the cars off to Radarek for the next Round, or the car can be shipped back to you for the repair and you can send it along to the next track (Radarek / Edmonton) for the next Round. The choice is yours. Please let Dale know asap, since he plans to ship the cars out this coming weekend; thanks.

According to the Rules, a 3 lap penalty will need to be applied to the car at the end of the series.

Allan