The snow is falling and wind is blowing, good day to work on some bumpers for the coach.
We're putting the uprights in the rear bumper starting with cutting an small piece of clip
then grinding it to fit inside.
It just happens to be the width of the hemostat, after grinding the fit is checked and adjusted. Once
the fit is good the piece is then placed on a piece of plain old scotch tape and placed inside the bumper.
Once in place and adjusted, it's then glued at one point, and adjusted before the glue sets up.
Once set the tape is removed and glued at the other point. Use a small paper clip with some
glue and let it wick around the piece.
This is done for each piece. Got four in, have one more to go. After this all sets up it will be
scraped and sanded. Hopefully after finishing and paint, the inperfections don,t show.
Have much more to do on the car, but with the weather outside sure not going anywhere
so I will spend the day playing with this.
All for now
Kevin