Home Racing World

this car is great, perfect scale 1\32, another fine job by Bob

I went with a brass chassis and tried something new

First I got a 1\16" X 1\4" K&S brass bar and cut pieces 7\16" long drilled a 1\8"th hole 3\16 from top center of the 1\4"

Next was some 1\16" X 1\2" and drilled for motor mount



using a small ball end bit in my dremel I cut a slot in some K&S brass tube, the 3\32 X 3\16 for the1\4 tab to fit, connecting the 2 rails is some 1\8th K&S round tube for 3\32 axles



adding the motor mount I then bent some 1\16" rod to run along the top of the motor mount and tabs I then cut out the axle tube



still need to add my body mounts and guide bracket

hope you like ik :text-thankyouyellow: :text-thankyouyellow:

Well you are making a nice chassis there. Nice progress.

That car looks great with the wheel wells opened up, Smooth chassis build to Jon, this should be a looker.

Bob

thanks guys, hope to get more done today