Power supply for Tire Razor

[Mayberryman]

I have two tire machines at this time, A Razor and an old JK that used a hinge and set screw to sand down set screw rims. My problem is that my old trusty Koford power supply went up in smoke after about 18 years. I have seen these 5 amp power supplies on that auction site and I was wondering if the 5 amp model would power the razor and JK or would I need the 10 amp model.

[HomeRacingWorld]

5 Amp works fine for me. All I have used for years.

[waaytoomuchintothis]

Spencer, shoot me a PM.

[RazorJon]

http://homeracingworld.us/viewtopic.php?f=24&t=1433

this is what I use, 2 amps perfect for the Tire Razor, motor break-ins and motor dipping

[waaytoomuchintothis]

Here's what I was looking for. I knew I had this somewhere.
http://www.amazon.com/Precision-Variabl ... S1XFNSJSP4

[RazorJon]

that 1 Harry got was just like that but with free shipping :music-rockout:

[goosenapper]

I use the same 2 amp variable job that Jon does, and it works great for truing both tires and wheels on 1/32 and 1/24 cars. I've also used it to power the Razor while grinding and chopping wheels down for inserts, so it does all I've asked of it.

[waaytoomuchintothis]

I never know about free shipping at Amazoon these days. Anything over $35 is supposed to be free shipping, but it doesn't count with some of the vendors they show, and does with others. Then when you check out, they don't put the free shipping on. You have to find it and select it. It seems like they are always changing things for no good reason, like we are all chimps with attention spans that run out.

[Audi1]