Re: Anyone out there CAD adept? Found someone

[Dogsbody]

I've a sketch (and photo for reference) that I'd like someone to make plans out of for me then I'll take the file and have a CNC shop do the routing on MDF. Table is 8 x 20, three lanes with 4" lane spacing.

Thanks, Mark

[frank9129]

Mark,
I wanted a Gypsy track. I went to Chesapeake Small Craft and they routed the entire track for $250. I furnished the MDF.
The only problem I had was the dust packed in the slot. It took some digging with a small screw driver. But it was not all that bad.
Good luck on your plans and routing. I took a piece of Artin track for them to see what a slot looked like.