Home Racing World

This is our first table track we are doing Riverside Raceway
lots to do lots of fun

Set the elevations and guard rails also played with the plaster cloth
Guard rails are thin azak type material pinned with 1/8 rod we will be running 1/32 and 1/24 cars on the track

Excellent.
Nice to see a little helper too. Father son time is missing in lots of kids today with phones, video games and computers.

Yup, looking great!

Looks good. It's nice when you can start adding scenery.
Dave

go wood?
pretty nice though.
speed

i had so much track we had to do it. next track will be wood short track looking forward to it.

Looks like a fun layout and having drift aprons, etc makes for a lot more fun! :)
Great to see your son was involved in the build as well!
:banana-dance:

Making progress, built one more rail in turn 7 also got carried away with the foam spray
built the mound for the Champion Bridge also built the controller pits and car stations on edge of facia almost for got the catch fence is up but not complete needs posts. That piece of foam is a cutoff in turn 7

Interested to watch the foam. I knew a guy who did most of his scenery that way....spray foam and caulk. Claimed it was faster and easier on the cars......
I was thinking of doing the same thing so this is helpful!

This is what I have to do to get off the floor. Thanks for the great pics olddude13. I bet that foam will look good with paint. The plaster cloth looks great. Was it time consuming to work with?

Thanks, i may still cover foam with plaster cloth in some spots i filled the large voids with scrap packing foam then sprayed around take your time if it gets on the track it comes off after cured do not mess with it wet let it cure, Foam cures pretty fast depends on temp mine cured in a few hours you can save your cutoffs and put under your plaster cloth for hills and such

Nice idea using foam. Good work ' any more progress.

Very nice work , thinking about doing just about the same thing, I have a Scaletrix track set that will run 6 cars wirelessly . will be using 1/4 inch foam board as boarder, keeping a little room for movement of the track when the cars are running