Home Racing World

WOW! Now THAT is robust!
I like the inclusion of the powered scuff fixture as part of the station - pretty slick idea!
:D

That is nice! :text-bravo:

Harry your wife did a very nice job!!! ok your work isn't bad either lol...very nice pal
Fred aka Pickles

Woe you cut up some perfectly good 8'' peel-n-stick sanding disks! Great job , nice track for some Wing Sprints...

Thanks all.

Yes, I have a huge stack of those sanding disks so might as well use them up :) We run about everything here, not much into modern sprints but the classics see action.

Nice design Sir, robust, roomy and fuctional. Well done
Bob

Nice job Boss! Pretty fancy for Skunkworks.

Pretty cool Harry they look strong enough to stand on

Richard

That's fantastic, great work!

You know what's going to happen, right? Get Agee and Tony over there, and they'll have sanding disk races from one end of the sanding disk to the other. :lol:

Thanks guys. Dang it, you are right Kurt, knew I cut those slots a little too long :)

You might want to cover the scuff stations with a mat when they are not being used, someone might put something conductive across the tape and that would not be good, especially if you have a big power supply and the driver's stations are not indivdually fused.

Thanks Rich. They are fused though, used the same ATM fuse holder as on our road course.



Might be a crude way, but I like the simplicity of these fuse holders.

Dang,that is a nice design!

Rusty