Home Racing World

The Scalextric PCR chassis for the RSR Porsche is in stock and likely at dealers now too again in North America. C8543 is the part number.

Wahoo!

I need that! :lol:

Scott

They're cheap... so yes you do! :laughing-rolling:

Mine is here!

Got mine too.
Bob

Hey Dave
what is the story with this PCR chassis? Is this new or has been around for a while?
Also, I was under the impression that the PCR chassis would only take inline pods...this seems to take all 3 configurations (which is good in my book).
Are we going to see PCR chassis for more models?

Slot.it 3D printed PCR underpans are currently available for BMW Z4, BMW E30 M3, Honda Civic, Porsche 911, MG6, Ford Sierra, Mini F56, Volkswagen Passatt and BMW 1 Series.

From the website..

Hi Dave - does the new Scalextric Porsche RSR have a new body compared to say the #86 Gulf Porsche? Its hard to tell from the photos. That new RSR is a great looking car!

Interestingly, I went to LeMans in 2016 and saw the RSR Porsche race, along with the Ford GT. And of course saw the infamous Toyota finish (or lack of finish).

Thanks RvE

The body is the same, just the chassis change sir.

ok so that makes little sense since the PCR chassis are not made by them we make them and they are in our warehouse not on demand at Shapeways.

I am presently racing a Falken-liveried RSR with the PCR chassis. Using a Slot.it sidewinder pod (.5 offset) and a V12/4 23k motor, it's definitely competitive on our track (150 ft routed) against similarly powered GTs. Planning on a long can anglewinder next. Too bad no additional PCR chassis will be offered.

Thanks Moose.

Of all the talk, your the first with a report on your equipped model.