Guide holder
Posted:
Tue Feb 10, 2015 8:28 pmby frank9129
I was working on a Ranch Design chassis when I got heavy handed. I broke the guide holder.
What do I do now? Is there a replacement guide holder available.
The chassis is under a Mach V. The kids love the way the motor screams around the track. 14" straights give it a chance to wind out.
Re: Guide holder
Posted:
Wed Feb 11, 2015 12:24 amby 143_Racer
Send Steve an e-mail. He may have parts.
liberty@ranch-design.comRegards,
Frank
Re: Guide holder
Posted:
Wed Feb 11, 2015 1:03 amby pfuetze
if Steve doesn´t have any parts left, 3D print could be a solution for the guide holder. (or scratchbuilding out of PS?)
Re: Guide holder
Posted:
Wed Feb 11, 2015 3:57 amby walker
How many parts has the bracket broken into ?
If possible glue them together with c/a, put the unfragmented bracket on the scanner, print it out, cut it out, glue it onto a sheet of styrene of appropriate thickness, drill, dremel, sand - that' s it.
If it is broken too much, put the center section on a sheet of scaled paper and mark the two screwholes exactly. Then you can design the rest to your own specs.
Walker