Page 1 of 3

ProNoMag 2016 - results are in!

PostPosted: Thu Sep 17, 2015 1:02 am
by pfuetze
ProNoMag 2016 - proxy race on a wood track

Date: february 21, 2016

number of cars per entrant: max. 3
The track: app. 78ft. 3 lane wood track, latex paint, copper tape for the rails - magnets have no effect
the race: race will be run in lane 1 and 3, 25 laps practice, 25 laps race, the slowest 5 times will be deleted
the power supply: each lane has a seperate adjustable powersupply, 1.25 to 19V @ 3 Amp available
the timing: IR light bridge and laptimer 2000
the controllers: available controllers: 90/75/60 ohm parma eco, 45/35/25 Parma eco, 25/18/13 parma eco, 15/11/8 parma eco, i will choose the controller where the car is driveable as its best during the practice laps.
entry fee: 15 Euro (is used for return shipping of car)

Rules:
1) car must be approximately 1/43rd
2) max. width 50.8mm
3) no fluid may leak out, no grease, oil or braid juice may pollute the track, no tire glue or similar
4) teams may ask for a special voltage where the car should be run.
the standard racing voltage depends on the motor. I will run all cars @ 12V, SCX and Carrera motors @15V, G9330 & Fyrebox@9V, Kyosho@16V, KyoshoX@13V.
5) car must have a body that looks like a car, race look prefered, but not necessary
6) no silicone tires, rubber and PU are fine
7) no pin guides (like carrera or artin)
8) all tires have to touch the track
9) cars must run 20 qualitfication laps on lane 1 prior to the race. Cars must get a fastest lap in this heat under 13 seconds to qualify for the race. Please don´t worry about this rules, stock SCX or Kyosho cars can do it easily. Only the fastest 20 cars from the qualifying will run the race. qualifying times will be posted with the race times.

concours de elegance: the best looking car will be voted by the host and get a special price.

wide open rules again, ladies and gentleman, so build your fastest, smoothest 1/43rd car for this race. just tune your stock SCX car a little and maybe blow the doors off all others, built something that was not seen before, it´s up to you.
Who will have the fastest car?

list of prizes by now:
tbd
....

have fun, Peter

Re: ProNoMag 2016 - February 21, 2016

PostPosted: Thu Sep 17, 2015 8:55 am
by Cjent
Ummmm???????????????? Might have time to build something....................

Re: ProNoMag 2016 - February 21, 2016

PostPosted: Fri Sep 18, 2015 7:21 pm
by dc6287
In for this one!

Re: ProNoMag 2016 - February 21, 2016

PostPosted: Thu Jan 07, 2016 1:52 pm
by pfuetze
works started on the chassis for the BARC Porsche, which will be entered by the Puddle Dude Race Team :)

Image

Dillerman2 cars arrived today, first entry to arrive on the track :)

Image

Image

Image

Re: ProNoMag 2016 - February 21, 2016

PostPosted: Thu Jan 07, 2016 3:05 pm
by LloydL
OOh, they look mean! Must get the decals on my car!

Regards, Lloyd.

Re: ProNoMag 2016 - February 21, 2016

PostPosted: Thu Jan 07, 2016 3:37 pm
by BARC 1
I'm in this year. Expect to see some BARC factory cars entered.<grin>

Good to see you recycling the BARC Porsche that you had for testing.

I have a new design for you to tryout. CCR 1 and CCR 2( Credit Card Racer). Parts arrived in the mail to improve the motor mount on the CCR so I will get busy and get a new CCR chassis specially built for the race.

Entries to date look awesome.

Cheers


Dan

Re: ProNoMag 2016 - February 21, 2016

PostPosted: Thu Jan 07, 2016 3:47 pm
by pfuetze
looking forward to run the CCR´s :D

Re: ProNoMag 2016 - February 21, 2016

PostPosted: Mon Jan 11, 2016 11:56 pm
by pfuetze
The BARC Porsche is finished and already took some laps on the Desmo. Right now, the Minis are only going behind the Porsche by three tenth of a second.

Image

Re: ProNoMag 2016 - February 21, 2016

PostPosted: Tue Jan 12, 2016 10:43 pm
by BARC 1
January 12 Kleskun Hills Raceway

Image

The BARC team continued with it's chassis set up and went back to the drawing board to come up with a better handling inline chassis then had previously been tested.

The two unique chassis designs were put through their paces today and the team principle was pleased with the results.

" As a new team to this scale and event we are running a little blind as to what the competiton might have to offer. Earlier testing last year at DESMO indicated we were on the right track with the basics, but needed chassis work to make the most of the power we had. This year we have focused on a drivable chassis that will instill confidence in the drivers to push these cars to the limit."

Both cars performed well, and there is not much more we can do to prepare them for the Race in February. They just need to be painted and they can be loaded in the transported to get them to DESMO

Image

Image

Image

Image

Re: ProNoMag 2016 - February 21, 2016

PostPosted: Wed Jan 13, 2016 1:14 am
by pfuetze
great words from the BARC Team again :D

very nice chassis work, the guys from the Puddle Dude race team can´t wait to get them in their hands :)
The Porsche Cayman bodies look great too, looking forward to see some progress.

In the meantime, the PDRT is thinking about another entry, the orange MCA is maybe getting a new printed chassis using Carrera Go! parts (motor and gears) along with printed wheels :)

and what also happens if there is an upcoming race:

Image

Re: ProNoMag 2016 - February 21, 2016

PostPosted: Fri Jan 15, 2016 11:01 am
by BARC 1
Cars are painted. I'll give them a week to dry and then package them up to send to the DESMO circuit.

Image

Re: ProNoMag 2016 - February 21, 2016

PostPosted: Fri Jan 15, 2016 3:22 pm
by pfuetze
oh, they look great, Dan!
can wait to get them in my hands!
very nice paint and decals!

Re: ProNoMag 2016 - February 21, 2016

PostPosted: Fri Jan 15, 2016 4:28 pm
by pfuetze
in the meantime, from Berlin, the cars from dr.freak and taz arrived ...

Image

Image

Image

Image

looks like a strong competition this year - they are sooooooo smooth .....

Re: ProNoMag 2016 - February 21, 2016

PostPosted: Sat Jan 16, 2016 6:29 am
by ourwayband
You folks are building some great looking rides!!
This will be a great one to watch.

Rusty

Re: ProNoMag 2016 - February 21, 2016

PostPosted: Sat Jan 16, 2016 7:51 am
by cyclone60
All AWSOME cars :clap: :clap:
Keep up the good work ! :text-bravo: