Hogging out window techniques?
Posted: Sun Dec 04, 2016 2:15 pmHome Racing World
Your Slot Car Home On the Net!
http://www.homeracingworld.us/
Hogging out window techniques?
Page 1 of 1
Posted: Sun Dec 04, 2016 2:15 pmRe: Hogging out window techniques?
Posted: Sun Dec 04, 2016 3:15 pmDremel and milling bit. Fine tune angles with small file.
Re: Hogging out window techniques?
Posted: Sun Dec 04, 2016 5:59 pmNice find. You could almost leave the windows in the Van and only remove the glass in the cab. As Harry mentioned I would use a dremel with care and then use a file
Cheers
Dan
Cheers
Dan
Re: Hogging out window techniques?
Posted: Sun Dec 04, 2016 6:51 pmAll good ideas!
Thanks,
Nerf
Thanks,
Nerf
Re: Hogging out window techniques?
Posted: Mon Dec 05, 2016 1:10 amdrill bit, multiple holes, file afterwards ...
much work stay, however you do it...
for a nice and clean result, small files are the way to go i think.
much work stay, however you do it...
for a nice and clean result, small files are the way to go i think.
Re: Hogging out window techniques?
Posted: Mon Dec 05, 2016 7:37 amLeast intrusive method I use is to heat up a #11 xacto blade and use the normal sharp side. Like a hot knife through butter.