Home Racing World

the adjustable wheel base chassis for FF050 motors is ready! it was easier than expected to upscale the FF030 adjustable wheel base chassis.
again with 2 different options for mounting the body: 2 body stems or 4 pcs body holders on the side of the motor (i prefer this solution).
3mm brass rods or tubes to be used for connecting the parts of the chassis.

will order it after christmas from shapeways to give it the first try & fit and report ....

Ciao,
Peter

A new 030 and now a 050. Great Peter!

Peter, is that a chassis you designed or found on Shapeways? I just picked up a 1/43 AMX and was looking for a chassis for it. Seemed too small for a brass one.


Sent from my iPad using Tapatalk

What's the guide post diameter?

Thanks.

Dan

@Mike: i designed this chassis. I already designed and used 3D printed chassis. For various motors (FF030, FF050, H0 Boxer motor like SH-030A) with or without motorpod.
i will order a first prototype after the christmas holidays and report how it works.

@Dan: guide post diameter is 3mm