Page 1 of 1
Re: Lowering an Artin Viper
Posted:
Sat Mar 16, 2013 7:14 amby Tigeracer
I like what you have done! Nice job!
Greg
Re: Lowering an Artin Viper
Posted:
Sat Mar 16, 2013 1:42 pmby sirslotsalot
Great cutaway job on the end bell!!! I'm going to try that on my SCX and Carrera motors. I normally put a 5/64 drill hole in the top of the end bell for lubing the brushes but your set up is even better. Thanks for the excellent idea!!
Kihm
Re: Lowering an Artin Viper
Posted:
Sat Mar 16, 2013 5:01 pmby Broman62
Re: Lowering an Artin Viper
Posted:
Sat Mar 16, 2013 6:56 pmby sirslotsalot
Tom,
Hope all is well with you. I like leaving the cut-out open so I can hit 'er with the power washer. Just have to strap the car down securely first. Wish me luck. LOL!!!!!!!! Please don't take this post seriously.
Kihm
Re: Lowering an Artin Viper
Posted:
Sun Mar 17, 2013 5:39 pmby Cjent
Really a good job, Roland. First Artin Viper I have seen!
Re: Lowering an Artin Viper
Posted:
Mon Mar 18, 2013 2:31 pmby pfuetze
Great job on the lowering, Roland!