Home Racing World

Anyone own/race TSR 1/24 or 1/32 RTR chassis/cars designed/promoted by Philippe de Lespinay?

I heard they were very fast and handle well right out of the box, comparable to any of the European metal chassis cars. I may have to put a milder motor in them for my plastic track, but that's OK.

I have the 32 scale chassis with the Fly Sunred SR21 body and too be honest it has been hit and miss for me. Superslab also has one and I think he has had more success with his, but then he makes every car go fast!

The pin guide did not work for me on the TSRF and I replaced it with a regular guide.

In our Group 5 proxy we have a couple of Australian entries with Plafit 3300 chassis equipped cars and they have proven to be very competitive.

If you are interested in buying my TSRF, then drop me a PM, it is not being used and I might as well sell it if there is interest.

Chris

AFAIK, or can recall, at one time Philippe had an open bet that the TSR (TSRF) cars were as competitive and better set up to race right out of the box than ANY other RTR car on the market. But that's our beloved Philippe. :-)

I have always liked his chassis design, which he first used commercially on the 1/40 scale Cox Super Scale cars, which I have a few of.

Uh huh, He also had oven front property in Missouri for sale too. :whistle:

They were ok but just not suited for our needs here. For 1/24 the H&R with urethanes did the best job.

I've got three of them, one 1/32 and two in 1/24, one of the latter being an F1 chassis. I've had them for years and not used any of them but thats just me, not a criticism of the chassis.

Ditto on the pin guide. Grrrr......

Had a set of the 1:32 cars. Was not impressed and sold them in rather short order.

The H&R complete chassis doesn't need much to be very competitive with any solid chassis and they are about as cheap as anything you can buy new. $50. Stick an MT 15,500 motor in one and it can be all you want in terms of speed and drivability. I wasn't too happy with any of the H&R motors, but that was just my experience.

Not sure how the dollar trades with Oz, but Bruce Patterson probably has some decent frames that are probably competitive price wise and race wise.

The simple Parma Womps (brass preferred) are easy to lengthen and make competitive, The 1/32 LVJ chassis is easy to solder a piece under it to make it whatever length you want.

For under $40 or so you can buy used cars on Ebay that have Dynamic chassis. Those are suited to most any car you want to build and are easy to adapt an FK 180 motor to them.

Lot of options for good running, cheap frames in 1/24.