Ferrari 313pb

1/32nd Scale Slot Car Forum
Discussions for 1/32nd Scale

Ferrari 313pb

Postby patrol » Thu Nov 20, 2014 1:42 am

hiya

As a newbie id like to as a question which may sound a little silly
Over the years I have bought a couple of 312's from Slot It and one from Slotter. This time around I bought the Policar version of the Ferrari and I notice that the rear wing is at a lower position. Is this correct and if so is it normal in a race to lower it
Might be silly but worth asking.

Mike
patrol
 
Posts: 6
Joined: Wed Nov 19, 2014 10:55 pm

Re: Ferrari 313pb

Postby ElSecundo » Thu Nov 20, 2014 6:51 am

No worries about the rear wing height. The PB ran with the wing in all positions, sometimes near the top of the rear fins, sometimes mounted very low, just off the rear decklid.

Most wings have multiple mounts, so they can be configured for high or low downforce. Get up close to most race cars, and you'll see a bunch of mounting holes and/or slots where the wings are mounted.

And don't worry about the width, either. These cars are much wider than you might think. For such a short car (a little over 11 and a half feet), it's 6'2" wide.
ElSecundo
The Great One
 
Posts: 1372
Joined: Wed Aug 29, 2012 6:26 pm
Location: Sellersburg, IN

Re: Ferrari 313pb

Postby patrol » Thu Nov 20, 2014 9:08 pm

Hi Guys

many thanks interesting

Mike
patrol
 
Posts: 6
Joined: Wed Nov 19, 2014 10:55 pm


Return to HRW 1/32nd Scale



Who is online

Users browsing this forum: No registered users and 7 guests