by nhdungeonracer » Tue Nov 11, 2014 10:50 am
We'll be limiting this to 4 teams, so get your teams together now if possible. Minimum # of drivers on a team is 2.
We are planning to start at 11am (can be adjusted if needed)
We will be using the fuel stops feature.
Heats will be 15 minutes each. We will cycle through all the lanes 6 times (30 heats)
At present, the plan is to give each team 30 chips to designate what car they plan to run. 15 will be of one color, and the other 15 will be another color. These must be turned in at the beginning of each heat. One color will represent Vintage, and the other color will represent Group C.
If you don't have a Vintage type car, there will be plenty available to borrow (right Bob? smiley: tongue)
Group C guidelines
Open to any Slot.It Group C car (Jaguar, Porsche, Lancia, Mazda, Toyota, Mercedes)
Must run inline motor drive setup.
Motor limited to 22k, and must be S can style.
Open gearing.
Any brand silicone tire on rear.
May run any wheel designed for 1/32 cars. Plain insert wheels shall have inserts.
Wheel/tire assembly shall remain under body (not sticking out when viewed from above)
Vintage Sports car guidelines
- Street and racing sports cars produced before 1968
- Production made plastic chassis cars (Scalextric, Fly, MRRC, Ninco, Carrera, Pinkcar, Reprotec, etc)
-Approved list of Motors rated near13k rpm's at 12 volts
--- Artin White End bell 13k
--- Cartrix TX1
--- Ninco NC1, NC8, NC11
--- Pink Car Power Plus 1
--- Power Slot PS-2 (small can motor)
--- SCX RX4
--- H&R 14K (gearing limited to 8/28)
--- DR Vanski (gearing limited to 8/28)
--- M&T-1 and SL-1
- Maximum width over the Tires is 2.000 inches. Tires may not stick out from the body to reach this measurement.
- Maximum Wheel size is 15x7 front and back.
- Max tire width on front is 9/32" (.280")
- Currently allowed rear tires
--- Indy Grip IG2002 and other Indy Grip tires which are not wider or taller in diameter.
--- YellowDog # 1204RY
--- Supertire # 1204RC
---Quick Slicks 1507200 and 1507205
---Paul Gage - tires with part #'s that have 07 in the middle should be ok (example 20073)
-Gear ratio to be 3 to 1 (8/24, 9/27, 10/30) May use a smaller pinion or bigger spur.