3D printed Lola T260

[racer1h]

Latest 3D printed slot car.....always wished they made this in 1/32 (slot it sidewinder pod)....another nimrod file.

[slothead]

Nice car. How is the wing mounted so it can survive contact or a rollover?

The CG Slotcars Shadow DN4 has a rubber brace holding it in place that can flex with contact and then spring back into position. Of course, the Shadow is such a low profile car I've never even come close to rolling it.

[FC47]

Well that was quick eh?
Came out nice!

[racer1h]

Wing is just glued on with a bit of epoxy. Rubber supports would be nice. Just glue it back on like the slot it group c cars etc.

[-Nimrod-]

Great work again Mate
Your a Machine pumping them out

Cheers
NiMROD