Here goes nothing...

[Ember]

I was mucking about with some brass and a soldering iron and came up with....



It is for a resin MG PA/PB kit. The kit came with a resin chassis, but it seemed like it should be a relatively easy conversion to brass.



When I've got it sorted I'll take some of the guff out of the shell itself.



It fits. I can probably trim up the tube for the front axle a bit.

I've still got to work out how to do the guide mount, among other things.

[munter]

Looks good...guide mount and motor mount?

Brass tube, held vertical for the guide mount.
Motor mount...is it going to be sidewinder?

[Ember]

Guide. Motor will be slimline soldered/glued in place. I've still got to cut rear tube to allow for crown and glue Oilites in place.

[Wolseley Hornet]

[Ember]

I'm really only making it up as I go along. I just hope it works when its together. The main bits are about as square as I can get by eyechrometer. I've done quite a bit of desoldering an tweaking to get it this far.

[whitworthnut]

Excellent start Ember. Is that a Pendleslot body?

[Ember]

Yup. Not a bad one either. The resin chassis looks pretty good, but I bought it with the intent of trying a brass one for it. Handy actually to have the resin chassis to get ideas from.

[HomeRacingWorld]

Well good morning, that is a nice start. Way to go.

[waaytoomuchintothis]

I would expect nothing less from you, kiddo. You do well with whatever you put you hand to. Great work.

[RazorJon]

our little girl is all grown up now :lol:
great job :music-rockout:

[Ember]

Got to get it to run yet. :lol:

[SRQSloter]

Lookin good Ember. Nice clean solder work. :handgestures-thumbup:

[Reslotted]

Don't you just hate it when shes "mucking about" and it's about 10 times better than your most serious efforts..
Seriously tho Embs, Good work.

[FootScoot]

I can say it is much, much better than my first effort. I haven't laid iron to solder lately, but will be rusty when I start to. I just make it up as I go along. I never have a definite plan of action. :)

[Ember]

It got a guide holder fitted yesterday. And then pretty much rebuilt again. Not quite, but I had grabbed the wrong sized axle tube for the rear and the Oilites wouldn't fit. Replaced that. Trimmed a few things up. Now I have to move the rear tube forward a little. And find some other wheels because the BWA15s seem too big. I have BWA13s but no tyres. Argh! No matter how many parts I have in stock they are never the right ones.