I did a test fit and it looked good, so then just a drop of CA and slide them into place:
It’s also a nice way route the motor leads:
Ron
Front axle stops
3 posts
• Page 1 of 1
Front axle stops
by oz10k » Sun Jan 26, 2014 12:51 pm
I got out an old Ninco and was struck by how much vertical play there was in the front axle. So I decided to make some axle stops. I used Evergreen StripStyrene 3/16†square tube #253. I cut off a piece, then cut that on a 45 degree angle:
I did a test fit and it looked good, so then just a drop of CA and slide them into place:
It’s also a nice way route the motor leads:
Ron
I did a test fit and it looked good, so then just a drop of CA and slide them into place:
It’s also a nice way route the motor leads:
Ron
- oz10k
- Posts: 34
- Joined: Tue Mar 05, 2013 2:39 pm
- Location: Chicago suburbs
Re: Front axle stops
by dreinecke » Sun Jan 26, 2014 1:04 pm
Ron - great job. That is exactly how a number of us do it here. The nice thing is the side product of getting a wire routing path.
-
dreinecke - King of the Dum-Dums!
- Posts: 7360
- Joined: Wed Aug 08, 2012 5:39 pm
- Location: Colorado
Re: Front axle stops
by SlotCarCorner » Mon Jan 27, 2014 12:20 pm
-
SlotCarCorner - SCC Mechanic
- Posts: 736
- Joined: Tue Sep 04, 2012 7:45 am
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests
Powered by phpBB® Forum Software © phpBB Group