could sell me even though it had been discontinued..
I sanded it, washed it, and gave it a coat of testors enamel silver for a base coat.. looked great.
Then I wanted to run this transparent lime gold / green over it.. Also Testors enamel..
(however it was recently purchased on clearance, sealed but a few years old)
I shook and shook and shook to make sure it was mixed well.. I'm kicking myself for not shooting
a test onto some spare styrene..
This is what I got.. so disappointing.
How do I remove it without warping or damaging the resin?
Or do I just let it completely dry / harden for a week and try to sand it smooth?
(Pictures don't show how uneven it is.. every silver circle is a crater)
Thanks,

.