KYOSHO EDRIVING Transform a diecast model cars to a slot ca

[OL Mike]

Kyosho eDriving: Transform a diecast model cars to a slot car!In addition to the fantastic new edition of the 2014 Scorpion buggy on the Kyosho Stand (see post below!) *We found “eDriving”: a new platform that allows you to turn the static model cars (1/43 scale) into slot cars! The operation is very simple and only takes a few minutes. Just unscrew it with a screwdriver and the two screws that secure the bodies diecast to the chassis and install the eDriving chassis visible in the photo which you can see if you press continue Of course, since the weight of the body diecast, performance is limited but, it’s pretty cheap (should be less than 30 euro) I think it might catch on with the scale modulars out there, who may be prepared to see their shelf queens actually move! I think this chassis has potential I like the way that you can adjust back and front to fit the whEEL WELLS OL MIKE IF IT 1/43 I LIKE IT

[pfuetze]

a chassis with a pin guide only? again for top heavy diecasts?
no way to adjust width?

[Cjent]

US DISTRIBUTOR HAS NO CLUE ABOUT THIS.

[OL Mike]

All can do is hope that US DISTRIBUTOR look's into this it would make my slot car world easier 1/43 thats the road for me

[Cjent]

Mike, I think if you look around, and with Ranch Design coming back soon, you find chassis similar to this are already available.
And with better mounting possibilities.

[OL Mike]

MY FORD HAD D SLOT THAT TOOK 2ND IN A DRAG RACE Maybe life would had been a little easier with this chassis :banana-dance: :flags-waveusa:

[masmojo]